Noxudol 300/900/UM-1600 undercoat application
 

6-a Precautions | 6-b Undercoat application

 
6-a Precautions
 
(1)Storing product

•Noxudol 900 and UN-1600 are solvent based product. Noxudol 300 is non-solvent based product.
Store in above 40 degrees less than 90 degrees condition.

•Using plastic under cap, store to minimize vaporization by contacting outside air.
•Use Noxudol undercoat product within several days.

 
(2)1 liter canister
●Make sure to mix product thoroughly prior to use
•Open internal seal of 1 liter canister.
 
●Heating the product
Noxudol 300, 900 or UM-1600 1 liter canister can be heated to make the product easier to apply
by using warm sitting water. Do not use boiling water.
Make sure to follow above mixing and seal opening procedure after heating.
 
(3)20 Liter (5 Gallon) pail
When opening pail, product may not be mixed evenly.
Make sure to mix fully to make product even. 20 liter (5 gallon) pail product
can be heated using band heater as shown below.
This will make product easier to apply. Make sure to have lid open when using band heater.
Make sure that product will not reach boiling point.
 
6-b Undercoat application